Flagpoles
Datasheet constraints: every range, checkbox and listbox field now states its direction
Showing changes from Rev 3
to Rev 4
in Flagpoles.
---
title: Flagpoles
…85 unchanged lines
- "Sealed structural calculations for the shaft and base"
- "Finish samples"
+constraint: all_of
```
…22 unchanged lines
- "ANSI/NAAMM FP 1001 compliance certification"
- "Mill and material certificates"
+constraint: all_of
```
…20 unchanged lines
- "Keys and winch handles"
- "Warranty documents"
+constraint: all_of
```
…122 unchanged lines
drawing_ref: "the flagpole schedule or site details"
default: deferred
+constraint: exact
```
…9 unchanged lines
derived: "exposed height, flag load, and design wind speed under ANSI/NAAMM FP 1001"
default: derived
+constraint: exact
```
…37 unchanged lines
step: 1
default: 1
+constraint: exact
```
…54 unchanged lines
- "Lockable cleat cover box"
- "Wire-center halyard"
+constraint: all_of
```
…76 unchanged lines
- "Yardarm with halyards at each end"
- "Gaff with halyard"
+constraint: all_of
```
…133 unchanged lines
drawing_ref: "the exterior elevations"
default: deferred
+constraint: exact
```
…95 unchanged lines
max: 25
step: 1
+constraint: min
```
…7 unchanged lines
max: 20
step: 1
+constraint: min
```
…16 unchanged lines
step: 1
default: 1
+constraint: min
```
## Spare parts shall be delivered to the Owner, boxed and labeled by pole location, at the demonstration of the halyard systems.
## The halyard is the one part of a flagpole that wears, and a halyard that parts leaves the flag at half-mast or on the ground until a replacement reaches a pole whose truck may be 40 ft up. A spare cut to length and fitted with hooks is replaced the same day with a messenger line; a spare ordered after the failure is replaced the following week. {note}