Laboratory Casework
Datasheet constraints: every range, checkbox and listbox field now states its direction
Showing changes from Rev 3
to Rev 4
in Laboratory Casework.
---
title: Laboratory Casework
…112 unchanged lines
- "Seismic anchorage details and calculations"
default: ["Product data for casework, finishes, work surfaces, sinks, fittings, raceways, storage cabinets, and hardware", "Dimensioned shop drawings of each casework run keyed to the service rough-in", "Finish, work surface, hardware, and service fitting samples", "SEFA 8 casework performance test report", "SEFA 3 work surface test report", "Chemical compatibility statement against the chemical use schedule", "Hardware and service fitting schedule"]
+constraint: all_of
```
…28 unchanged lines
- "Spare parts and touch-up material receipt"
default: ["Material-specific care and maintenance instructions", "Hardware and fitting adjustment procedures and replacement-parts data", "Record shop drawings", "Executed product and installation warranties", "Storage cabinet listing certificates and use instructions"]
+constraint: all_of
```
…129 unchanged lines
```datasheet
−label: Steel Casework Powder Coating Minimum Dry Film Thickness
+label: Steel Casework Powder Coating Dry Film Thickness
type: range
unit: mil
…2 unchanged lines
max: 5
step: 0.5
+constraint: min
```
…249 unchanged lines
max: 200
setpoints: [75, 100, 150, 200]
+constraint: min
```
…148 unchanged lines
setpoints: [0.75, 1, 1.25, 1.5]
default: 1
+constraint: exact
```
…80 unchanged lines
setpoints: [3, 4, 6, 8]
default: deferred
+constraint: exact
```
…108 unchanged lines
- "Nitrogen or other specialty gas"
- "Electrical receptacles in a casework raceway"
+constraint: all_of
```
…444 unchanged lines
max: 10
setpoints: [1, 2, 3, 5, 10]
+constraint: min
```
…16 unchanged lines
max: 10
setpoints: [1, 2, 3, 5, 10]
+constraint: min
```
…27 unchanged lines
- "Work surface joint adhesive or sealant of each type"
- "Spare glazing for glazed doors"
+constraint: all_of
```
…8 unchanged lines
max: 10
step: 1
+constraint: min
```
…15 unchanged lines
#### The most common cause of in-service failure in laboratory casework is not a fabrication defect but a reagent the material was never meant to see, left standing on a joint, followed by a cleaning agent that dulls the finish a little every day. Neither is covered by the warranty, and both are prevented by the Owner's care rather than by the specification. {note}