SynC · Topic
Storefront
These are the standards in SynC Standards that cover Storefront. Each one is a complete, plain-language specification: the scope it applies to, the requirements that govern it, and a structured equipment datasheet listing the values a project has to decide, with the standards each is verified against. All of it is written and maintained by SynC, free to read without an account, and published under CC BY 4.0.
A standard usually carries several topics, so most of the entries below also appear under neighbouring subjects. The topics each one carries are listed on its own page.
Standards
- Aluminum Entrances and Storefronts
Non-load-bearing extruded aluminum framing systems glazed with monolithic or insulating glass, and the aluminum stile-and-rail swing entrance doors integrated with them, at building perimeters and interior partitions. Covers framing depth, sightline, joinery, glazing pocket position, and thermal barrier construction; glass lite construction, insulating glass unit make-up, edge seal, and low-emissivity coatings; dry, wet, and structural silicone glazing methods; air infiltration, water penetration, structural wind load, thermal transmittance, solar heat gain, condensation, acoustic, windborne debris, and inter-story drift performance; entrance door leaf proportions, construction, hardware, thresholds, and weatherseals; anodic and organic finishes; perimeter anchorage, sill water management, and air and water control layer continuity; laboratory and field testing; installation, cleaning, protection, and warranty.
- Glass and Glazing
Architectural vision glass and glazing for storefronts, curtain walls, windows, exterior and interior doors, sidelights, transoms, borrowed lites, partitions, and other building glazing infill. Covers annealed, heat-strengthened, and fully tempered flat glass; laminated glass; coated (low-emissivity and solar-control) glass; insulating glass units (IGUs) including double and triple makeups; spandrel and ceramic-frit glass; safety glazing in hazardous locations per the International Building Code; glass strength and thickness determination under wind and snow load per ASTM E1300; thermal stress and edge-condition selection of annealed versus heat-strengthened versus fully tempered glass; nickel-sulfide heat-soak treatment for tempered glass; low-iron glass; warm-edge spacers and inert-gas fill; structural silicone and dry-gasket glazing methods; setting blocks, edge clearances, and glazing accessories; and field installation, testing, cleaning, and warranty of the glass and glazing materials.