SynC · Topic
These are the standards in the SynC Standards library that cover Glazing. Each one is a complete, plain-language specification: the scope it applies to, the requirements that govern it, and a structured equipment datasheet listing the values a project has to decide — ratings, materials, setpoints, and the standards each is verified against. All of it is free to read without an account and published under CC BY-SA 4.0.
A standard usually carries several topics, so most of the entries below also appear under neighbouring subjects. The topics each one carries are listed on its own page.
Non-load-bearing extruded aluminum framing systems glazed with monolithic or insulating glass, and the aluminum stile-and-rail swing entrance doors integrated with them, at building perimeters and interior partitions. Covers framing depth, sightline, joinery, glazing pocket position, and thermal barrier construction; glass lite construction, insulating glass unit make-up, edge seal, and low-emissivity coatings; dry, wet, and structural silicone glazing methods; air infiltration, water penetration, structural wind load, thermal transmittance, solar heat gain, condensation, acoustic, windborne debris, and inter-story drift performance; entrance door leaf proportions, construction, hardware, thresholds, and weatherseals; anodic and organic finishes; perimeter anchorage, sill water management, and air and water control layer continuity; laboratory and field testing; installation, cleaning, protection, and warranty.
Architectural vision glass and glazing for storefronts, curtain walls, windows, exterior and interior doors, sidelights, transoms, borrowed lites, partitions, and other building glazing infill. Covers annealed, heat-strengthened, and fully tempered flat glass; laminated glass; coated (low-emissivity and solar-control) glass; insulating glass units (IGUs) including double and triple makeups; spandrel and ceramic-frit glass; safety glazing in hazardous locations per the International Building Code; glass strength and thickness determination under wind and snow load per ASTM E1300; thermal stress and edge-condition selection of annealed versus heat-strengthened versus fully tempered glass; nickel-sulfide heat-soak treatment for tempered glass; low-iron glass; warm-edge spacers and inert-gas fill; structural silicone and dry-gasket glazing methods; setting blocks, edge clearances, and glazing accessories; and field installation, testing, cleaning, and warranty of the glass and glazing materials.
Aluminum-framed glazed curtain wall acting as the primary non-load-bearing exterior enclosure of a building — stick-built, semi-unitized, and unitized systems that span vertically across one or more stories and hang from the building frame at discrete anchors. Covers the assembly method, the water management principle and internal drainage, mechanically captured and structurally silicone-glazed retention, framing member sizing and thermal barriers, the vision and spandrel glazing selection tree the framing delivers, aluminum finishes, air and water penetration resistance, thermal transmittance and condensation resistance, acoustic performance, wind pressure and deflection criteria, thermal and seismic movement accommodation, wind-borne debris impact resistance, perimeter fire containment at the floor edge, anchorage and movement joints, perimeter air and water barrier continuity, fabrication, mockups, erection, and field water and air testing.